jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
Tekstowy podgląd strony 43 (kliknij aby zobaczyć)
KEX-M8886ZT ,M8886ZT-91
5. Details 1 Frequency characteristics adjustment function � The system changes submodes cyclically every time the [FM1/2] button is pressed when "AUDIO" is displayed. Set EQ Point 1 ¨ Set EQ Point 2 ¨ Set attenuation ¨ "AUDIO" � Set EQ Point 1 The system displays �P1� and EQ management number. The EQ management number ascends/descends every time the UP/DOWN button is pressed.The EQ management number consists of three digits (000 to 286). Initial value is 000 (no setting). � Set EQ Point 2 The system displays �P2� and EQ management number. The EQ management number ascends/descends every time the UP/DOWN button is pressed. The EQ management number consists of three digits (000 to 176). Initial value is 000 (no setting). � Set attenuation The system displays �L� and attenuation value. Use the UP/DOWN button to change attenuation within a range from 0 to -20 dB at increments of 1 dB. Attenuation value is shown in two digits from 00 to 20 (20 = -20 dB). Initial value is 00 (no setting). 2 level adjustment function � The system changes submodes cyclically every time the [TAPE] button is pressed when "AUDIO" is displayed. Set front ¨ Set rear ¨ Set woofer ¨ �AUDIO� � Set front The system displays "F" and level value.Use the UP/DOWN button to change level value within a range from 0 to -80 dB at increments of 1 dB. Level value is shown in two digits from 00 to 80 (80 = -80 dB). Initial value is 00 (no setting). � Set rear The system displays "R" and level value. Use the UP/DOWN button to change level value within a range from 0 to -80 dB at increments of 1 dB. Level value is shown in two digits from 00 to 80 (80 = -80 dB). Initial value is 00 (no setting).
� Set woofer The system displays "W" and level value. Use the UP/DOWN button to change level value within a range from 0 to -80 dB at increments of 1 dB. Level value is shown in two digits from 00 to 80 (80 = -80 dB). Initial value is 00 (no setting). Notes: 1) Pressing the TAPE button during adjustment of frequency characteristics is invalid. Pressing the [FM1/2] button during level adjustment is invalid. 2) The UP/DOWN button mentioned above means the [SEEK] (UP,DOWN) key. Filter 1 : ATT of 30 to 35 dB for receiving frequency Filter 2 : ATT of 5 to 10 dB for receiving frequency The filter should not cause the switch to be set to OPEN when the filter is ON. If setting the switch to OPEN cannot be avoided, duration
